Cannot run Schedule+ in Group Mode due to no postoffice set up.
Cause:
A Windows Messaging System (WMS) workgroup postoffice has not been installed. Schedule+ requires one of the following to run in Group Enabled mode: A Workgroup postoffice provided with Windows NT 3.x; a Microsoft Mail Server 3.x postoffice; a Microsoft Exchange Server postoffice; or a mail server with a valid MAPI 1.0 driver.
Solution:
Contact the Network Administrator and request a post office be configured via Microsoft Exchange.
NOTE: The following procedure describes how to set up a post office in Windows 95 and should be performed by the Network or Post Office Administrator.
Decide the location of the post office and who is to be the Administrator. Then enable sharing with workgroup users.
1) Click 'Start' to display the Windows 'Start' menu.
Start menu
2) Select 'Settings' and select 'Control Panel'.
Control Panel from Settings menu
3) Open 'Microsoft Mail Post office'. (The Post office wizard appears.)
4) Click 'Create a new Workgroup Post office'.
5) Click 'Next'.
6) Type the path (including network drive, if applicable) of the workgroup post office.
7) Click 'Next'. (The complete path of the new post office appears. If this path is not correct, click 'Back' to return to the previous screen.)
8) Click 'Next'. (The Administrator account details dialog box appears.)
9) Type information about the Account Administrator: (These details may be obtained from the post office administrator.)
a) Type the name.
b) Type the name of the administrator mailbox.
c) Type the phone number.
d) Type the location of the administrator's workgroup.
10) Click 'OK'.
